Patent-pending, Venturi-effect, tapped exhaust clamp for obtaining accurate lambda measurements in non-cat autos or other engines.

The Bosch LSU4.2 wide-band O2 sensor (shipped as part of the LM-1 kit) is rated to operate at an exhaust gas temperature of < 1300 degrees (F), and a sensor housing temperature of < 900 degrees (measured at the bung) for maximum accuracy and control.

Wall AC power adapter for LM-1 meter only.

Adapter for computers without Serial ports. This cable will convert Serial to USB. Hardware drivers included.

Mild Steel Bung & Plug Kit

Stainless Steel Bung & Plug Kit

Bosch LSU4.2 5-wire, wide-band O2 sensor. Replacement sensor for LM-1, LM-2, LC-1, and LC-1ST.

**LM-1 only** 10-ft. long, for direct connection of LM-1 to Bosch/VW plug on LSU4.2

**LM-1 only** 10-ft. long, for direct connection on LM-1 to cigarette lighter or accessory plug

6-ft. long, custom-molded serial cable for downloading logged data from LM-1 to your PC, or for programming/updating the LM-1 firmware.

The LMA-3 (AuxBox) allows a user to log and analyze 5 critical engine metrics. The 5 internal sensors are: 3-Bar MAP/Boost, RPM, Injector Duty Cycle, EGT/CHT, and 2-Axis Accelerometer.

The LC-1 is a complete wideband Air/Fuel Ratio sensor controller built into a sealed cable. It features the same award-winning patented digital measurement principal found in the LM-1 & LM-2

The Serial Program Cable will allow you to connect any of the following devices to your PC. (LC-1, XD-16, LMA-3, DL-32, SSI-4, TC-4)

Serial "Terminator Plug" replacement, for use with XD-16, LMA-3, LC-1, and DL-32.

The "Window Mount" will allow you to have the LM-1 mounted to your windshield. This will help provide a better view of the display while tuning.

This custom cable will allow you to connect and/or daisy chain the following products: XD-16, LC-1, LMA-3, DL-32, SSI-4, TC-4, & ST-12. Also used to connect the LM-1 to the XD-16.

Extended Bung & Plug (1 inch) Mild Steel

*Bosch Wideband Sensor Included* The LC-1 is a complete wideband Air/Fuel Ratio sensor controller built into a sealed cable. It features the same award-winning patented digital measurement principal found in the LM-1 & LM-2

The DL-32can record up to 32 channels of data from other MTS devices into a SD memory card. It also offers 5 internal sensors, and expansion inputs for future modules.

The TC-4 is a 4-channel thermocouple amplifier with two temperature ranges for exhaust gas temperature (EGT) or cylinder head temperature (CHT)

1GB SD (Secure Digital) Memory Card for LM-2 & DL-32 Dataloggers

This custom cable will allow you to connect and/or daisy chain the following products: XD-16, LC-1, LMA-3, DL-32, SSI-4, TC-4, & ST-12. Also used to connect the LM-1 to the XD-16.

The "DB" gauges are cost-effective and stylish 52mm (2 1/16") instruments available with blue or red LEDs.

The "DB" gauges are cost-effective and stylish 52mm (2 1/16") instruments available with blue or red LEDs.

This kit comes complete with the patented award-winning LC-1 Wideband Controller, DB-Blue Gauge, Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide.

This kit comes complete with the patented award-winning LC-1 Wideband Controller, DB-Blue Gauge, Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide.

The LC1+ kit includes an LC-1 wideband controller with O2 sensor, plus an SSI-4 multi-sensor interface.

The LC1-Duo Kit consists of 2 LC-1s (one for each bank), and a DL-32. This kit is ideal for most forms of racing, and offers a savings of nearly $100 vs. when purchased separately.

This kit comes complete with the patented award-winning LC-1 Wideband Controller, G2 Gauge, Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide.

This kit comes complete with the patented award-winning LC-1 Wideband Controller, G3 Gauge, Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide.

The "G2" AFR gauge (52mm, 2 1/16”) features a high-speed stepper motor, through-dial backlighting, and an illuminated pointer.

The "G3" AFR gauge (52mm, 2 1/16”) features a high-speed stepper motor, through-dial backlighting, and an illuminated pointer.

The LM-2 Kit (Single Wideband O2) includes the LM-2 meter, Bosch wide-band oxygen sensor, 8 ft sensor cable, cigarette-lighter power adapter, analog in/out cable, ODB-II/CAN interface cable, SD memory card, USB cable for PC connection, weld-in bung and plug, LogWorks software CD, and quick-start guide. Carrying Case also included! P/N: 3806

The LM-2 Duo Kit (Dual Wideband O2) includes the LM-2 meter, (2) Bosch wide-band oxygen sensors, (2) 8 ft sensor cables, cigarette-lighter power adapter, analog in/out cable, ODB-II/CAN interface cable, SD memory card, USB cable for PC connection, (2) weld-in bung and plug kits, LogWorks software CD, and quick-start guide. Carrying Case also included! P/N: 3807

Replacement Power Cable. Included with LM-2 kit

OBD-II / CAN Interface Accessory Cable for LM-2

Replacement 8ft Sensor Cable. Included in LM-2 kits

Analog Input and Output Accessory Cable for LM-2 (Needed for RPM Input)

LM-2 Serial Patch Cable makes the LM-2 MTS Compatible (LC-1, LMA-3, DL-32, SSI-4, TC-4). Four pin Molex to serial 2.5. *Not included with LM-2 kit*

Replacement USB Cable for LM-2. Included in LM-2 kits

The "Window Mount" will allow you to have the LM-2 mounted to your windshield. This will help provide a better view of the display while tuning.

The new Innovate Motorsports G2 Vacuum/Gauge Kit (2 1/16", 52mm) is a complete standalone gauge, and is not Innovate MTS compatible. Mechanical.

The new Innovate Motorsports G3 Vacuum/Gauge Kit (2 1/16", 52mm) is a complete standalone gauge. Mechanical.

The new Innovate Motorsports G2 Water Temp Kit (2 1/16", 52mm) is a complete standalone gauge. Electronic. *Not Innovate MTS compatible*

The new Innovate Motorsports G3 Water Temp Kit (2 1/16", 52mm) is a complete standalone gauge. Electronic.

The new Innovate Motorsports G2 Oil Pressure Kit (2 1/16", 52mm) is a complete standalone gauge. Electronic. *Not Innovate MTS compatible*

The new Innovate Motorsports G3 Oil Pressure Kit (2 1/16", 52mm) is a complete standalone gauge. Electronic.

This kit comes complete with the patented award-winning LC-1 Wideband Controller, G4 Gauge (2 1/16", 52mm), Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide.

This kit comes complete with the patented award-winning LC-1 Wideband Controller, G5 Gauge (2 1/16", 52mm), Bosch 5-wire Wideband 02 Sensor, Bung, Software CD, and quick start guide.

The "G4" AFR gauge (52mm, 2 1/16”) features a high-speed stepper motor, through-dial backlighting, and an illuminated pointer.

The "G5" AFR gauge (52mm, 2 1/16”) features a high-speed stepper motor, through-dial backlighting, and an illuminated pointer.

Innovate Motorsports 18 ft sensor extention cable for the LM-2 and MTX-L

These kits include the Auto Timer-Air/Fuel Display, Control Unit, Wire harness, Mounting Accessories, and installation manual. P/N: 3830

The OT-2 is an OBD-II vehicle interface for Apple TM iPhone TM or iPod Touch TM and includes software performance computer, efficiency calculator, and advanced diagnostics.

OT-2 / LC-1 Kit: OBD-II & Wideband AFR WiFi Interface

Designed to prolong the life of your turbocharger and/or oil. The Innovate Motorsports Auto Timer will allow a vehicle to idle the engine for a timed period, with the ignition key removed. This conveniently allows the engine oil and turbo center cartridge to cool down properly and prolong turbo and oil life. This can be done by two programmable count down presets, or you can use its three auto timer modes (Low-Normal-High)

Inductive Clamp Accessory for LM-2, DL-32, LMA-3, and RPM Converter

Powersports 12mm to 18mm O2 Bung Adapter

Carrying Case for LM-2 Digital Air/Fuel Ratio Meter (Black)

The new LM-2 "Basic" Kit (Single Wideband O2) includes the LM-2 meter, Bosch wide-band oxygen sensor, 8 ft sensor cable, cigarette-lighter power adapter, USB cable for PC connection, weld-in bung and plug, LogWorks software CD, and quick-start guide. P/N: 3837

Extended Bung & Plug (1 inch) Stainless Steel

The Serial Program Cable will allow you to connect the MTX-L and LM-2 to your PC

Extended Bung & Plug (1 inch) Titanium

Innovate Motorsports 3 ft sensor extention cable for the LM-2 and MTX-L.

The new Digital MTX-L Air/Fuel Ratio Gauge utilizes the only 100% digital Wideband air/fuel ratio technology on the market, and the Built-in DirectDigital™ Wideband Controller reduces wiring and simplifies installation.

The new Digital MTX-L (POWERSPORTS) Air/Fuel Ratio Gauge utilizes the only 100% digital Wideband air/fuel ratio technology on the market, and the Built-in DirectDigital™ Wideband Controller reduces wiring and simplifies installation.

COMING SOON 2012 MTX Digital, Vacuum/Boost & Shift Light Gauge Kit, Dual Function

COMING SOON 2012 MTX Digital, Oil Pressure & Pressure Gauge Kit, Dual Function

COMING SOON 2012 MTX Digital, Water Temperature & Battery Gauge Kit, Dual Function

COMING SOON 2012 MTX Digital, Exhaust Gas Temperature (EGT) Gauge Kit, Dual Function